Browsing Tag

Cura

Slicers: Which one to use?

A few minutes ago I was rolling into my fb timeline and found this post about a comparison made between the most common slicers: Slic3r - http://slic3r.org/ Cura - https://ultimaker.com/en/products/ Simplify3D - https://www.simplify3d.com/…

Laying out 3D Prints in Cura Slicer

Laying out 3D Prints in Cura Slicer When it comes to laying out 3D prints in our slicing program, one of the most important things to consider is how overhangs and bridges will be supported. In all slicer programs, there is a way to…