My favorite filament the Hatchbox 1.75mm Black PLA 3D Printer Filament – 1kg Spool (2.2 lbs) – Dimensional Accuracy +/- 0.05mm Is selling cheap!
In the past I have used filament from many other manufacturers. I switched to using Hatchbox after finding their spool prices cheaper by 13 dollars.
I havent found a need to change the temperature with this product, however I did notice the filament is able to withstand bending to a much greater extent. The filament from zen snapped when I bent it past a certain again. The filament from Hatchbox can be bent up to 180 degrees and still not break. In fact, it might take a few such bends before the filament breaks.
5 Star rated Filament sells dirt cheap. you should buy it before prices go back up! Read on about the product below! 🙂 Happy days!
Nice to know! Just wondering, are all filaments expected to bend a little and be able to withstand some punishment? If I were to make some shock towers for a gas R/C buggy and drive over jumps and have hard landings should I expect them to break each time or last at-least a few days, weeks, months? I know it depends on the driver so it might not be an easy question to answer. But it sounds like this filament (Hatchbox) has some “give” to it and would be very forgiving during hard impacts.