Build plate Adhesion

    1
    3D Printing Q&ACategory: General QuestionsBuild plate Adhesion
    Stephen Seelos Staff asked 2 years ago

    How do you print just on the glass of the cr-10?

    Mark replied 2 years ago

    You need to make sure your bed is level and nozzle and appropriate distance from the glass bed, it might be these causing it not to stick. Make sure you glass is clean and grease free, some suggest dish soap or alcohol/methylated spirits. If that doesn’t work for PLA a thin layer of glue stick (pritt stick) or hair spray (spray off the bed so you don’t get it on the printer) or for abs a small amount of abs slurry (abs dissolved in acetone).