Getting Sticky! – 3D Printer Chat 3D Printing Show Episode 004

1 463

Get real time updates directly on you device, subscribe now.

Getting Sticky! – 3D Printer Chat 3D Printing Show Episode 004
5 (100%) 3 votes

In this episode …

  • Bed Adhesion, the good, the bad, the ugly …
  • Myths and rituals – Do you really need to stand on one leg pointing south? Listen to find out …
  • Print Surfaces – What works?
  • Z gap and levelling – The tricks and techniques
  • Heated beds – Important or not needed?

Get real time updates directly on you device, subscribe now.

1 Comment
  1. Tom Baxter says

    I really like these original podcasts with Chris, Daniel, & Miles. It’s just good engaging conversation. Also… I won’t be sending Miles any hate mail because I too am always using rafts when I print. 🙂

Leave A Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. AcceptRead More

A FREE 3D Printer?

We are Giving away 1 reviewed ULTIMAKER 3 ! To one lucky winner. Grab your entries!
Giveaway Expires In:
DONT MISS OUT..
close-link