DIY Mosfet Board

This topic contains 3 replies, has 2 voices, and was last updated by  Pavel 5 days, 23 hours ago.

  • Author
    Posts
  • #17840
    Profile photo of AptPupil
    AptPupil
    Participant

    I am looking for a schematic and BOM to make my own mosfet board. I know they don’t cost much, but I have a ton of components and I love to solder.
    Thanks in advance,
    Jeff

  • #17878

    Pavel
    Participant

    In addition to the processor chip (for example, MEGAxxx), you need input / output adapters to the sensors / interface / drives of the printer. And then – you need a PCB, and then – the software of processor chip.

  • #17882

    Pavel
    Participant

    Сan add a some RAM to optimize the spooling.

  • #17968

    Pavel
    Participant

    Sorry, the buttons and the display – it’s also a board, but now they are not fashionable to set because of the possibility of control from a PC. Did not take into attention PSU, sensors and other purchased components.

You must be logged in to reply to this topic.