Reply To: The best way to print a 3D configurator?

Home Forums Tutorials Coding Developers The best way to print a 3D configurator? Reply To: The best way to print a 3D configurator?


Participant
#23076

2 Common G-Code Commands for 3D Printing
G90 and G91
Your printer can use either incomparable or relative arranging. Preeminent arranging infers that you will exhort your 3D printer to move a right XYZ encourage. Relative arranging is used when you have to tell the printer how far it should move from the present region. Send a G90 charge to encourage your printer to use inside and out arranging or a G91 for relative arranging. The lion’s offer of your code record will most likely use inside and out arranging since the slicer has adequately chosen the right XYZ bearings to move to. In any case, if you haven’t the foggiest about the past position of the tool head, or you simply understand that you have to move the head a particular partition along a center point, you can use relative arranging. While G90 and G91 control the arranging mode for the X, Y, and Z tomahawks, you can similarly use M82 or M83 to set your extruder (E-center) to preeminent or relative arranging. Kodak Customer Support

A FREE 3D Printer?

We are Giving away 1 reviewed ULTIMAKER 3 ! To one lucky winner. Grab your entries!
Giveaway Expires In:
DONT MISS OUT..
close-link