Reply To: Prusa is Mk2 Calibration Issue

Home Forums Support 3D printer support Prusa is Mk2 Calibration Issue Reply To: Prusa is Mk2 Calibration Issue


Participant
#19581

Hello! 1st post
…. but I’ve been through a lot recently so you might find some bits I found early useful…

If you’re in Pronterface (or if there is different I haven’t seen as of yet) and talking to the printer, send it m119 in the command window. GCodeM119.. It sends back the end-stop sensor status for each one.. Just check they are toggling when you think they are.. Z, X and Y, just make sure..

Regards
Neal

A FREE 3D Printer?

We are Giving away 1 reviewed ULTIMAKER 3 ! To one lucky winner. Grab your entries!
Giveaway Expires In:
DONT MISS OUT..
close-link