Reply To: g code

#15197
Profile photo of Apostolis
Apostolis
Participant

Hello @Italo,

You are right! Hahahaha! I work on a project and i want to tell the printer just to hit in 4 points. I need a g code to see how i can start a programme, to set the temperature in 230 C, to wait until the extruder reach this temperature, to start the fans working and then to close all these and close the programme with correct commands, for my printer’s safety. For this reason, i need a guide g code, to start and end a g code, without the part of printing.

Of course, I could desing 4 little circles and put them on simplify, to do this! But i want to do something more formal!

Please someone help me! 😛 🙂