Reply To: Support Assemble

Home Forums Support 3D printer support Support Assemble Reply To: Support Assemble


Here we go again


Poly fuses seem to have recovered , all cables re-done , applied power – ran up repetier – hot end and bed still not heating up – more investigation required.

So How to check the motor side ?

Give the arduino a new sketch to check the motors , done that , reset the arduino and all the motors kick into life.

So now the problem is the +- on the left hand side that distributes power to D8,D9,D10 – – q1,q2 look fine q3 looks discolored so next job is to test them.

But’s that is for another day.



A FREE 3D Printer?

We are Giving away 1 reviewed ULTIMAKER 3 ! To one lucky winner. Grab your entries!
Giveaway Expires In: