3D Solutech Silver Metal 1.75mm ABS 3D Printer Filament 2.2 LBS (1.0KG)

3 332
3D Solutech Silver Metal 1.75mm ABS 3D Printer Filament 2.2 LBS (1.0KG)
Rate this post

A Really nice Silver ABS Filament!

This ABS 1.75mm 3D printer filament more than fills the bill. It is very accurate in diameter, and not too rigid. But it is rolled up abit too tight on the reel. I have run into filaments that seem to be almost done by a kids hand though so this one is fine. The filament binds really well. After several hours of printing, I’ve had perfect prints from this brand of filament. You should check it out below.

ps. It came vacuum sealed so no moisture problems 😉 ds.

 


Also published on Medium.

3 Comments
  1. PhoenixFlame says

    This seems interesting, never knew about this for a printer.

    However what printer models is this compatible with? Dell or HP too?

    Thank you.

    1. Daniel Faegnell says

      Sure could be.. If they made a good 3D Printer. 🙂

  2. Karen says

    Interesting!

Leave A Reply

Your email address will not be published.